| Weight | 2.6 oz |
|---|---|
| Dimensions | 1.35 × 1.35 × 1.51 in |
| Features | • Triaxial Configuration |
| Applications | • Tower Cranes |
DKA Digital MEMS Accelerometer
Highlights:
Compare
Jewell Instruments DKA Series Accelerometers are an excellent choice for cost to performance trade off. The DKA is based on silicon micro-machined MEMS Capacitive Accelerometer technology and designed for low power and high stability.
Additional information
Performance Specifications
Performance Specifications
Static/Dynamic
| Measurement Range (g)1 | ±2 | ±4 | ±8 | ±10 | ±20 | ±40 |
| Output Interface | RS-232, RS-485, RS-485 MODBUS, and TTL | |||||
| Calibration Deviation (mg) | <1.0 | <1.0 | <1.0 | <1.0 | <1.0 | <1.0 |
| Measuring Axis | X, Y, Z (3-axis) | X, Y, Z (3-axis) | X, Y, Z (3-axis) | X, Y, Z (3-axis) | X, Y, Z (3-axis) | X, Y, Z (3-axis) |
| Bias Temperature Coefficient (%/°C, typical) | 0.01 | 0.01 | 0.01 | 0.01 | 0.01 | 0.01 |
| 0° Output Error (mV) | <0.005 | <0.005 | <0.005 | <0.003 | <0.003 | <0.003 |
| Cross Axis Sensitivity(%) | 1.0 | 1.0 | 1.0 | 2.0 | 2.0 | 2.0 |
| Resolution @ 1Hz (mg, max) | <1.0 | <1.0 | <1.0 | <1.0 | <1.0 | <1.0 |
| Nonlinearity (% of Full Scale, max) | <0.5 | <0.8 | <1.0 | <1.0 | <1.0 | <1.0 |
| Lateral Vibration Sensitivity Ratio (%) | 1.0 | 1.0 | 2.0 | 5.0 | 5.0 | 5.0 |
| Bandwidth (Hz, 3db) | 725 | 725 | 725 | 725 | 725 | 725 |
| Noise Spectral Density (µVolts/√Hz) | 21.0 | 21.0 | 21.0 | 86.6 | 86.6 | 86.6 |
| Output Rate (Hz) | 5, 10, 25, 50, 100, 200, 500, and 1000 | |||||
| Protocol | Jewell Std Protocol and MODBUS RTU Protocol | |||||
Electrical & Environmental
| Input Voltage (Vdc) | 9 to 36 |
| Operating Current | <60mA at 12Vdc |
| Operating Temperature Range | -40 to +85°C |
| Storage Temperature Range | -55 to +100°C |
| Shock Resistance | 100g (11msec ½ sine) |
| Vibration Resistance | 20grms @ 20-2000Hz |
| Seal | IP67 |
| Connector | Standard M12 |
Notes:
1: Intermediate ranges available. Custom ranges available by request.
Specifications subject to change without notice due to continued product development.
Downloads
Downloads
| DKA-300 Datasheet |
Related Products
JMA-100/200/300 Analog MEMS Accelerometer Series
Highlights:
The JMA-100/200/300 series is available in single (JMA-100), dual (JMA-200), and triple (JMA-300) axis configurations. This presents a robust and rugged design for industrial use, but with the benefit of low-cost MEMS technology.
LSB Series Linear Accelerometer
Highlights:
The Jewell LSB Series Accelerometer is a general-purpose ±0.5G to ±20G linear device designed for rail, commercial, and aerospace sensing requirements. Available with either pin or a circular connector termination.
 |
 |
DXA-100/200 Series Linear Accelerometer
Highlights:
The Jewell DXA-100/200 Series single or dual digital accelerometer takes Jewell’s highly accurate analog closed-loop sensor technology to the next level.
 |
 |
